Drawing:                  

                                                

Product  name：

 T8 LED tube light kits                                                                 

Serial number：

 LZPC-8-M

Specification:

 ￠26mm*1.0mm

PCB size:

18.5mm×1.0mm (width×thickness)

Assembling：

2 PC cover + 1 heat sink + 2 caps

PC cover type：

1： transparent

2： transparent with inner strips

3： diffused

Material:

1： Polycarbonate

Transparent PC Material / Milky Diffused Material

Raw material mode：

PC-3110ZHP、PC-1250Z-100、PC-S2000UVR、PC- 2215、PC-EKD2108.

Flame retardant: 94-V2、 94-V0

2:  AL 6063 (6063-T5 navigational aluminum)

Power supply device:

Internal power supply

Transmittance:

1:  Transparent PC cover  ≥90%,

2:  Diffused PC cover  ≥ 87%.

Beam angle:

 ≥168°

Features:

1： High transmittance、

2： Uniform luminous、

3： Anti-yellowing: not going yellow in 3-5 years 、

4： High anti-UV index、

5： Good freezing resistance: Non-embitterment above -50℃ ;

6： High thermo stability: without distortions below 130℃.

7： Glow-wire test past 650℃.

8： The 6063-T5 aviation aluminum is good at rapid heat 

       dispersion.

9： The warranty can be up to 5 years, under the proper

       temperature conditions in doors.

Report:

We can supply the material reports: UL、MSDS、SGS、REACH and so on.

Test method:

1： Salt mist test、

2： High free drop anti cracking test、

3： high and low temperature test、

4： Anti-yellowing in outdoor exposure test.

Inspection accordance:

Professional standards

Tips:

1:  The general problem of the PC cover mostly refers to appearing irregular cracks in the use of the tube lighting, which is mostly caused by chemical substances. The reason is that the prestress of the polycarbonate and BPA of the raw material can produce chemical reaction when they meet chemicals.   

 

2:In case rise the problem as above, Paying attention to not applying some substances as following:

A:  Industrial Thinner、

B:  Alcohol、

C:  Plate washer water 

D:  The instant glue whose PH≥6.

E：The printing ink on the PCB and the glue on the leds should   apply materials with the property of un-printing and volatility.