Drawing:

 

 

                        

Product name：

 T10 LED tube light kits

Serial number：

        LZPC-10-S

Specification:

      0.6m、0.9m、1.2m、1.5m、2.4m

Compound mode：

The tube is composed of 1/2 PC cover + 1/2 heat sink + two end caps

which can be matched with the transparent PC cover、transparent with inner strips PC cover and milky diffused anti-glare PC cover. The both sides can be equipped with plastic caps. Plastic ratable caps.

Material:

The PC cover is made of pure transparent polycarbonate material and milky diffused frosting material. The specifications are following：PC-3110ZHP、PC-1250Z-100、PC-S2000UVR、PC-2215、PC-EKD2108. Their fireproofing grad can reach up to 94-V2 and 94-V0.

The heat sink uses the material of 6063-T5 navigational aluminum.

Power supply device:

Interior power supply

PCB size:

18.5mm×1.2mm (width×thickness)

Transmittance:

The transmittance of the transparent PC cover can be over 90%,

And the milky diffused PC cover can be over 87%.

Beam angle:

 159°

Features:

High transmittance、uniform luminous、anti-yellowing: not going yellow in five years 、high UV index、good freezing tolerance: Non-embitterment under the temperature 50℃ below; High thermo stability: without distortions under the temperature 130℃.Flame retardant wire test past 650℃. The 6063-T5 aviation aluminum is good at rapid heat dispersion. Under the proper temperature conditions in doors, the warranty of tube kits can be up to 5 years.

We can supply the material reports: UL、MSDS、SGS、RoHS and so on..

Test methods:

our products have passed the tests: salt mist test、High free drop anti cracking test、high and low temperature test、anti-yellowing in outdoor exposure test.

Inspection standard:

professional standard

Kindly reminders:

The general problem of the PC cover mostly refers to appearing irregular cracks in the use of the tube lighting, which is mostly caused by chemical substances. The reason is that the prestress of the polycarbonate and BPA of the raw material can produce chemical reaction when they meet chemicals.

The user should pay attention to not applying industrial Thinner、alcohol、plate washer water and the instant glue whose PH is over 6. The printing ink on the PCB and the glue on the leds should apply materials with the property of un-printing and volatility.